Horizon Fitness Elite IC7 User's Guide download pdf (Page 7)

1312

TROUBLESHOOTING

& MAINTENANCE

CONSOLE OPERATION

1) After installing the battery (CR2032 3V), the display will turn on (Fig.

A) and the console will make a beep sound before entering TIME and

DATE setup. Press “MODE” button to confirm. When complete, the

console will display the main screen (Fig. B).

2) Press "SET" to enter set-up mode. Press “SET” button to adjust the

TIME value and press “MODE” to confirm setting. Repeat the process to

set up DISTANCE, CALORIES and PULSE.

3) During your workout, TIME, DISTANCE, and CALORIES will count up

from 0. If you have set a TIME, DISTANCE or CALORIES TARGET, the

console will count down from the target you have set to 0. When you

are within 30 seconds of completing your target, the console beeps. If

you keep exercising after reaching your target, the console will count

up from 0. When a pulse signal is detected, the console will beep

consistently.

4) Press "SCAN" during your workout and the display will change the

feedback every 6 seconds (Fig. C).

5) Press “MODE” during your workout and the display will only show RPM

and SPEED. The console will cycle between RPM and SPEED every 6

seconds.

NOTE:

• After 4 minutes of inactivity, the console will display TEMPERATURE and

TIME and DATE (Fig. D). Press any button to return to the main screen

(Fig. B).

• Removing battery will restore default settings.

• If the computer displays abnormally, re-install the battery.

• Battery Spec: 3V CR2032 (1PC).

• To replace the battery, remove the screw and the battery cover on the

back of the console.

Fig. A

Fig. B

Fig. C Fig. D

HZ14_OG_Elite_IC7_Rev1_1.indd 12-13 6/30/14 2:09 PM

1 2 3 4 5 6 7 8 9 10 11 12 ... 24 25

No comments

Horizon Fitness Elite IC7 User's Guide Page 7