Horizon Fitness T101 User's Guide download pdf (Page 10)

TENSIONING THE RUNNING BELT

The running belt has been properly adjusted at the factory before it was shipped. At

times the belt can move off-center during shipment.

Running belt should NOT be moving during tensioning. Over-tightening

the running belt can cause excessive wear on the treadmill as well as its

components. Never over-tighten the belt.

CAUTION

If you can feel a slipping sensation when running on the treadmill, the running belt

must be tightened. In most cases, the belt has stretched from use, causing the belt

to slip. This is a normal and common adjustment. To eliminate this slipping, turn

the treadmill off and tension both the rear roller bolts using the supplied Allen

wrench, turning them ¼ turn to the right as shown. Turn the treadmill on and check for

slipping. Repeat if necessary, but never turn the roller bolts more than ¼ turn at a

time. Belt is properly tensioned when the slipping sensation is gone.

TIGHTENS RIGHT SIDE OF ROLLER

TIGHTENS LEFT SIDE OF ROLLER

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

No comments

Horizon Fitness T101 User's Guide Page 10