Horizon Fitness GS1050T User Manual download pdf (Page 7)

ASSEMBLY STEP 2

A Pull LEAD WIRE through RIGHT CONSOLE MAST.

After pulling the lead wire through the mast, the top of the

CONSOLE CABLES should be located at the top of the

mast. Detach and discard LEAD WIRE.

B Open HARDWARE BAG 2.

C Move RIGHT LINKAGE ARM into position and attach to

ELEVATION FRAME. While holding RIGHT CONSOLE

MAST in the upright position, tighten PRE-ATTACHED

BOLT using flat wrench to attach RIGHT LINKAGE ARM.

D Attach RIGHT CONSOLE MAST to MAIN FRAME

using 1 BOLT (D), 1 FLAT WASHER (E) and 1 WAVY

WASHER (F).

E Lift the RUNNING DECK until FOOT LOCK LATCH on

side of treadmill is fully engaged.

F Remove CONSOLE from box and place out of the way.

G Lower the treadmill RUNNING DECK from the folded position

by stepping on FOOT LOCK LATCH on lower right side.

WAVY WASHER (F)

29 mm

Qty: 1

BOLT (D)

Qty: 1

FLAT WASHER (E)

27 mm

Qty: 1

HARDWARE BAG 2 CONTENTS :

BOLT (D)

FLAT WASHER (E)

WAVY WASHER (F)

CONSOLE CABLE

RIGHT CONSOLE MAST

LEAD WIRE

MAIN FRAME

RIGHT LINKAGE ARM

ELEVATION FRAME

PRE-ATTACHED BOLT

FOOT LOCK LATCH

If you have attempted to move the treadmill from the box and

the machine has sprung open and cannot be assembled, refer

to the troubleshooting section in the TREADMILL GUIDE in

order to restore the treadmill to its proper position.

ATTENTION

NOTE: Be

careful not to

pinch any wires

while assembling

the right console

mast.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments

Horizon Fitness GS1050T User Manual Page 7

Comments to this Manuals

Related products and manuals for Treadmills Horizon Fitness GS1050T