HARDWARE BAG 4 CONTENTS:
ASSEMBLY STEP 4:
Open HARDWARE BAG 4.
Slide 1 WAVY WASHER (J) onto each HANDLEBAR SHAFT.
Slide the LEFT LOWER HANDLEBAR onto the HANDLEBAR SHAFT. Be sure the LEFT LOWER HANDLEBAR is
positioned the same as shown in the diagram.
Slide the LEFT UPPER HANDLEBAR onto the HANDLEBAR SHAFT. Using 4 BOLTS (H) connect the UPPER and
LOWER HANDLEBAR as shown in the diagram. Do not tighten any bolts until all 4 are started.
Secure the handlebar assembly using 1 WASHER (I) and 1 BOLT (C).
Repeat STEPS C-E on the opposite side.
NOTE: Be sure to attach WASHER (I) as shown in STEP E DIAGRAM.
A
B
C
D
E
F
ASSEMBLY S TEP 4
HARDWARE BAG 5 CONTENTS:
ASSEMBLY STEP 5:
Open HARDWARE BAG 5.
Run wires from MAIN FRAME BRACKET through the CONSOLE MAST.
Attach CONSOLE MAST to the MAIN FRAME BRACKET using 4 BOLTS (C) and 4 WASHERS (L).
Attach wires to back of CONSOLE.
NOTE: Do not pinch wires.
Attach CONSOLE to the CONSOLE MAST using 4 PRE-ATTACHED BOLTS.
Slide WATER BOTTLE HOLDER into back of CONSOLE.
A
B
C
D
E
F
ASSEMBLY S TEP 5
Comments to this Manuals