NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
Remove PRE-ATTACHED BOLT & WASHER from CONSOLE MAST.
Slide LOWER HANDLEBAR onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED WASHER & BOLT.
Remove PRE-ATTACHED SET SCREWS from right UPPER HANDLEBAR.
Slide UPPER HANDLEBAR onto LOWER HANDLEBAR and secure by reinserting PRE-ATTACHED SET
SCREWS.
Remove PRE-ATTACHED SCREWS located on the front and back of the HANDLEBARS.
Attach HANDLEBAR COVERS with PRE-ATTACHED SCREWS.
Repeat on other side.
A
B
C
D
E
F
G
After handlebars are assembled they will rotate freely – be cautious. Until
the machine is fully assembled, do not grab the handlebars for support.
Comments to this Manuals